

The Eibach Platinum Rear Spring - 5 in OD is an individually sold rear competition springs for suspension hardware matching the listed seating diameter. Select the free length and rate around the rear suspension geometry, installed height and intended setup.
Eibach’s Platinum design uses high-tensile spring steel and flat-ground ends. Use the diameter designation in the specifications: the 3.5 in group is listed by inside diameter, while PR1600.500.0075 is listed by outside diameter.
Includes:
- (1) selected spring
Specifications
| SKU | Free Length (in) | Seating Diameter | Rate (lb/in) | Block Height (in) | Spring Deflection (in) |
|---|---|---|---|---|---|
| PR1600.500.0075 | 16.00 | 5.00 O.D. | 75 | 2.47 | 13.53 |
Spring deflection is the manufacturer’s spring compression-travel figure. It is not damper stroke, wheel travel or a vehicle load rating. Account for preload and the installed spring stack.
Fitment
| Fitment | Requirement |
|---|---|
| Vehicle Make | Universal/Custom |
| Vehicle Model | Universal/Custom |
| Application | Match spring seating diameter, free length, installed height, spring rate and compression clearance to the suspension hardware. |
| Diameter convention | Outside diameter; not a coilover spring inside diameter. |
FAQs
Are these springs sold in axle pairs?
No. Each SKU supplies one spring.
Is the diameter an inside or outside measurement?
Use the explicit designation in the specifications. The ESS springs and PR1600.500.0075 use outside diameter, while the 3.5 in Platinum group uses inside diameter.
What determines the correct spring rate?
Select rate around vehicle load, suspension motion ratio, installed spring height and the intended track or terrain setup.
What must be checked before installation?
Match the seating and end configuration, available space and installed height. Confirm enough spring deflection remains at full suspension compression.